To begin, lay the sparker across the top of the body to see how far down the metal box should be once it is placed inside. Now that you've tested the sparker, you will need to place it inside of the launcher. Leave the launcher in a well ventilated room while it's drying and don't forget to remove the threaded plug if it is screwed onto the bottom.
In addition, because the PVC cement is flammable, installing and testing the barbecue lighter too soon could cause a fire. For one, the glue must create a strong enough bond between each piece to ensure that air can not escape out of small gaps while launching to make the launcher as safe as possible. Now that the body is complete, you will need to wait 24 hours before moving onto the next step. Twist and slide the long tube into pace and rest the launcher on a flat surface to dry. Finally, take the 2 inch wide PVC and put glue around the exterior contact points while also applying glue to the reducer's interior contact points. Once the pieces have been covered with glue, push and twist the reducer into place. The new contact points will be inside the coupler and outside the reducer. After that, take the 4 inch to 2 inch reducer and repeat the process. Next, twist the coupler onto the PVC pipe until it has been pushed as far down as it can possibly go. To begin, put glue on the contact areas between the coupler and 4 inch wide PVC. Now that you've seen how it goes together, pull the pieces apart. If glue has gotten into the threads as a result of the gluing process, immediately wipe out the glue before it causes permanent damage. The fuel will be sprayed in through the hole in the back, and if the plug is glued onto the adapter, you will not be able to fire the potato launcher. Wipe off any excess glue before the drying process begins and move into a ventilated room as the pieces start to dry.įor the threaded plug, you must not glue it onto the female adapter. Once you have pushed the adapter on as far as it can go, leave the project alone for about five minutes before starting on the other side. Place the female adapter onto the tube with the threaded sides out and twist the component onto the tube to further increase the strength of the bond. Each section must be covered to ensure a strong fit can be created.
Start by rubbing glue across the contact points between the tube and female adapter. You may also want to open a window or turn on a fan to increase circulation.
Before starting, be sure to put on your mask and gloves to protect your body from the fumes. (Remember, the previous step was to check the sizes of parts, check orientation, and to be used for planning prior to gluing.) PVC cement dries quickly, so you will need to be quick while assembling this section. Once you've seen how all of the parts loosely fit together, pull off each of the components and get ready to permanently glue them together.
0 kommentar(er)
